Are part-worn tyres safe to buy? +
Part-worn tyres carry significant risks. While they are legal to sell in the UK, studies have found that a large proportion fail to meet legal standards — many have been previously repaired improperly, have internal damage not visible from the outside, or are close to the legal tread limit. The small saving is rarely worth the risk. New budget tyres from reputable brands often cost only £15–£25 more and come with a full warranty.
Is it safe to drive on a slow puncture to reach a tyre fitter? +
If the tyre is only slightly low and you can maintain safe control of the vehicle, you can drive a short distance at reduced speed — no more than a few miles at 20–30mph. Check the tyre regularly as you drive. If the tyre is visibly flat, the sidewall is bulging, or the car feels unstable, do not drive at all. Call a mobile tyre fitter to come to your location instead.
What are run-flat tyres and can any fitter work on them? +
Run-flat tyres have reinforced sidewalls that support the weight of the car even with no air pressure, allowing you to drive up to 50 miles at 30mph after a puncture. They require specialist fitting equipment and a TPMS reset after replacement. Not all garages can work on run-flat tyres, but most professional mobile fitters and tyre centres are fully equipped. Run-flat tyres are typically 20–40% more expensive than standard equivalents.
What happens during an MOT tyre check? +
During an MOT, the examiner checks that all tyres are the correct size and speed rating for the vehicle, that tread depth is at least 1.6mm across the central three-quarters, that there are no cuts, bulges, or exposed cords, and that tyres on the same axle are of the same type (e.g. not mixing radial and cross-ply). Incorrect tyre pressure is not an MOT failure but the examiner may issue an advisory.
How do I read my tyre size? +
Your tyre size is printed on the sidewall in a format like 205/55R16 91V. The first number (205) is the width in millimetres, the second (55) is the aspect ratio as a percentage of the width, R means radial construction, and 16 is the wheel diameter in inches. The number after (91) is the load index and the letter (V) is the speed rating. Your vehicle handbook and the sticker inside the driver's door frame show the correct size for your car.
Do I need to replace all four tyres at the same time? +
No, you do not need to replace all four tyres at once unless they are all worn. It is best practice to replace tyres in pairs (both fronts or both rears) to maintain even handling. The newer tyres should always go on the rear axle for stability, even on front-wheel-drive cars. Mixing tyre brands on the same axle is not recommended but is acceptable across different axles.